Tungsten Alloy swaged bar

Introduction of Tungsten Alloy swaged rod

The normal tungsten alloy rod after swaging, ultimate tensile strength and hardness would be increased greatly. The ultimate tensile strength of general tungsten alloy rod is 920 MPa, hardness is 25HRC. However, after swaging, the ultimate tensile strength can reach 1200 MPa, hardness is 35HRC. We could even control at 1400 MPa, 40HRC. This type of rod is one of our main products. Usually the composition of this kind of products is 92%WNiFe.

1. Dimension: Diameter≥8.3mm, Length≤700mm

2. Density: 17.0-18.10 g/cm3
3. Composition: W content: 92~95%, W-Ni-Fe
4. Surface: swaged state

 

Tungsten Alloy Military Swaging Rod Main Properties:

* High density
* High melting point
* Small volume
* Excellent hardness
* Superior wearing resistance
* High ultimate tensile strength
* High ductility
* High temperature resistance
* Low vapor pressure

 

Appliance of tungsten heavy alloy swaged rod

Tungsten alloy swaging rod can be use in military defense, such as depleted uranium penetrators, bullet, armor piercing, rifle bullet, sniper rifle penetrator, etc.

牌号	状态	密度	抗拉强度	延伸率	硬度	冲击韧性	屈服强度
Grade	State	Density (g/cc)	UST	Elongation (%)	Hardness (HRC)	Impact toughness (MJ/m2)	Yield strength (MPa)
W263	锻造	17.25±0.15	≥1450	≥8	≥35	≥0.3	≥1350
Swaging
W262	锻造	17.50±0.15	≥1450	≥5	≥35	≥0.3	≥1350
Swaging
W261	锻造	17.60±0.15	≥1050	≥6	≥35	≥0.3	≥900
Swaging
W253	锻造	17.40±0.15	≥1450	≥8	≥35	≥0.3	≥1375
Swaging
W243	锻造	17.60±0.15	≥1450	≥7	≥35	≥0.3	≥1375
Swaging
W232	锻造	18.10±0.15	≥1400	≥6	≥37	≥0.1	≥1350
Swaging
W231	锻造	18.30±0.15	≥1050	≥3	≥37	≥0.1	≥800
Swaging
W221	锻造	18.50±0.15	≥1350	≥2	≥37	≥0.07	≥1250
Swaging